Pressure Vessels Inspections

Tech Altura carries out Third Party Safety Inspections for various pressure Equipment based on International Standards and local authority regulations.We have API authorized pressure vessel inspectors to carry out in service inspection activities in oil & Gas, Petroleum and chemical industries vessels.

Air Receiver

• An air receiver, sometimes referred to as a compressed air tank, is an integral part of any compressed air system. The main purpose of this is to act as temporary storage to accommodate the peaks of demand from your system and to optimize the running efficiency of your plant.
• The main purpose of this is to act as temporary storage to accommodate the peaks of demand from your system and to optimize the running efficiency of your plant.

Air Compressor

An air compressor is a pneumatic device that converts power (using an electric motor, diesel or gasoline engine, etc.) into potential energy stored in pressurized air (i.e., compressed air). By one of several methods, an air compressor forces more and more air into a storage tank, increasing the pressure

Boilers

A boiler is a closed vessel in which fluid (generally water) is heated. The fluid does not necessarily boil. The heated or vaporized fluid exits the boiler. All internal walls and surfaces are inspected, looking for any signs of leaks, corrosion, overheating, or other structural issues within the boiler. Waterside areas. All waterside areas of the boiler are inspected, including blow-off, water connections, and steam areas

Calorifiers

Calorifiers are basically water storage tanks fitted with a suitable heating coil in their lower half. This can then be connected to an external heat source, such a gas boiler or a renewable energy system, for example a heat pump or a boiler for wood or pellets.

Expansion Vessels

• Expansion vessels, also known as expansion tanks, can be found in most domestic pressurized heating systems.
• If you have a combi-boiler, you will have an expansion vessel.
• This vessel contains air and water from the central heating system, and its purpose is to maintain the right level of pressure in the system.

Services for Pressure Vessels

Tech Altura Consultants help our clients to remain vigilant, performing regular status checks on the all the assets involved. We ensure the codes and regulations to ensure the safety and integrity of pressure vessels are common challenges around the world.

We carry out compliance checks and assessments are run according to code (API 510, ASME or PED). Our competent inspection engineers are supported by a variety of advanced NDT technologies, including UT, LRUT, laser scanning, and EMAT for non-accessible areas. Other services include repair scoping and QA/QC for repairs and alternation.

PRESSURE VESSEL SERVICES RANGE

• UT time of flght diffaction
• UT phased-array
• UT spot measurement
• Pressure vessel assessment
• Corrosion screening
• Corrosion mapping
• Scanning asset structures by 3D laser
• Historic data collection · Repair scoping
• Corrosion / support inspection
• Fitness for Service assessment